Yamaha HTR-5850 Stereo System User Manual


 
20
CONNECTIONS
Both FM and AM indoor antennas are included with this
unit. In general, these antennas should provide sufficient
signal strength. Connect each antenna correctly to the
designated terminals.
Connecting the AM loop antenna
1 Set up the AM loop antenna, then connect it
to the terminals on this unit.
2 Press and hold the tab to insert
the AM loop antenna lead wires
into the AM ANT and GND
terminals.
3 Orient the AM loop antenna
for the best reception.
The AM loop antenna should be placed away from this unit.
The AM loop antenna should always be connected, even if an
outdoor AM antenna is connected to this unit.
A properly installed outdoor antenna provides clearer reception
than an indoor one. If you experience poor reception quality, an
outdoor antenna may improve the quality. Consult the nearest
authorized YAMAHA dealer or service center about outdoor
antennas.
Connecting the FM and AM
antennas
TUNER
AM
ANT
GND
FM
ANT
75 UNBAL.
AM loop antenna
(included)
Ground (GND terminal)
For maximum safety and minimum interference,
connect the antenna
GND terminal to a good earth
ground. A good earth ground is a metal stake driven
into moist earth.
Indoor FM antenna
(included)
(HTR-5850 U.S.A. model)
Notes
01EN_HTR-5850_U.book Page 20 Tuesday, January 18, 2005 7:25 PM