Yamaha HTR-5850 Stereo System User Manual


 
33
PLAYBACK
BASIC
OPERATION
When playing a DTS-CD/LD, be sure to set the IMPUT MODE
to DTS.
If the digital output data of the player has been processed in any
way, you may not be able to perform DTS decoding even if you
make a digital connection between this unit and the player
depending on the player.
Displaying information about the input
source
You can display the type, format and sampling frequency
of the current input signal.
1 Select the input source.
2 Press AMP to select the AMP mode, then
press STRAIGHT so that “STRAIGHT”
appears in the display.
STRAIGHT
3 Press u / d to display the following
information about the input signal.
(Format) Signal format display. When the unit
cannot detect a digital signal it
automatically switches to analog input.
in Number of source channels in the input
signal. For example, a multi-channel
soundtrack with 3 front channels, 2
surround channels and LFE, is
displayed as “3/2/LFE”.
fs Sampling frequency. When the unit is
unable to detect the sampling
frequency “Unknown” appears.
rate Bit rate. When the unit is unable to
detect the bit rate “Unknown” appears.
flg Flag data encoded with DTS or Dolby
Digital signals that cue this unit to
automatically switch decoders.
Notes
CD MD/CD-R
TUNER
V-AUXDVD
AMP
VCR
DTV/CBL
MULTI CH IN
SLEEP
STRAIGHT
ENT.
EFFECT
AMP
then
PRESET/CH
A-E/CAT. A-E/CAT.
ENTER
01EN_HTR-5850_U.book Page 33 Tuesday, January 18, 2005 7:25 PM