Yamaha HTR-5850 Stereo System User Manual


 
21
CONNECTIONS
PREPARATION
Connecting the AC power cord
Plug the power cord into an AC wall outlet.
AC OUTLET(S) (SWITCHED)
U.K. and Australia models..................................... 1 outlet
Korea model............................................................... None
Other models......................................................... 2 outlets
Use these outlets to connect the power cords from your
other components to this unit. Power to the AC
OUTLET(S) is controlled by this unit’s STANDBY/ON
(or SYSTEM POWER and STANDBY). The outlet(s)
supply power to any connected component whenever this
unit is turned on. For information on the maximum power
(total power consumption of components), see
“SPECIFICATIONS” on page 81.
Memory back-up
The memory back-up circuit prevents the stored data from
being lost even if this unit is in the standby mode.
However if the power cord is disconnected from the AC
wall outlet, or the power supply is cut for more than one
week, the stored data will be lost.
If you are using 4 or 6 ohm speakers, set the impedance to
4 or 6 ohms as follows before turning on the power.
Be sure this unit is in the standby mode.
1 Turn off the power to this unit, and while
holding down STRAIGHT (EFFECT), press
STANDBY/ON.
This unit turns on, and the ADVANCED SETUP
menu appears in the front panel display.
2 Press PROGRAM l / h to move through the
menu and select “SP IMP.”.
3 Press STRAIGHT (EFFECT) repeatedly to
select “4 MIN”.
4 Press STANDBY/ON to turn off the power.
The setting you made is reflected the next time this unit’s
power is turned on.
Connecting the power supply cord Speaker impedance setting
CAUTION
EFFECT
STRAIGHT
STANDBY
/ON
While holding
down, press
l PROGRAM h
EFFECT
STRAIGHT
STANDBY
/ON
01EN_HTR-5850_U.book Page 21 Tuesday, January 18, 2005 7:25 PM